Mediacad has gathered the expertise to provide all phases of Mechanical, Electrical and Plumbing (MEP) Design and Drafting solutions. We have the technical expertise, right from formulating preliminary design concepts to drafting your own recommendations from preliminary design data or sketches of Design such as, Plan, elevations, sections etc.

Whether you are interested in 2D MEP services or 3D MEP BIM services, Mediacad can offer both or any of the two services at very affordable rates.

:: Our MEP Design Services include:

MECHANICAL SYSTEM

• Schematic heating and cooling system design
• Heating and cooling equipment selection
• Heat loss and/or gain calculations
• Plant room layout design
• Fire protection system design
• Duct layout drawings

ELECTRICAL SYSTEM

• Electrical schematics
• Electrical, power and lighting plans
• Electrical site plans
• Electrical one line diagrams (Riser Diagrams)
• Electrical panel schedules and distribution panels
• Wiring Diagrams
• Cable/harness Drawings
• Ladder Logic Drawings

PLUMBING SYSTEM

• Plumbing and Drainage Drafting Services
• Design and Drafting services for domestic water plumbing set up
• Natural and LP gas piping drafting and planning services
• Compressed air and medical gas system plan drawings
• Demolition and existing plan drawings
• Isometrics, Riser diagrams, details, schematics and schedules
• Shop drawings, As-builts, specifications and coordination
• Legends and addendums supplement plumbing construction drafts
• Equipment Schedule

PLUMBING AND DRAINAGE DESIGN AND CONSULTATION
SERVICES

• Establish plumbing Loads-Load analysis
• Establish utility stub outs and pipe sizes
• Locate and coordinate pipe sleeve requirements
• Determine pipe chase space requirements
• Specify sanitary fixtures
• Water supply and distribution plans and details
• Wastewater collection system

SANITARY STORM DRAIN SERVICES

• Soil report evaluation
• Layout of below and above grade piping
• Sewerage plans and details
• Establish sewer loads
• Establish main pipe size and co-ordinate stub locations
• Road, rain plans and details
• Expansion loops for seismic requirements
• Check contour drawings to establish ground cover for sewer lines
• Research slope requirements
• Vent sizing and routing
• Reservoirs and water tank details
• Roof drain calculation
• Pump sizing and location
  
  

  Our M/E/P BIM Services include:

• Conversion of 2D design drawings to 3D models
• Co-ordination among various MEP trades
• Collision detection
• Fabrication drawings
• Shop drawings
• Riser Diagrams, Schematic Plans
• Builders work drawings
• Schedules, Bills of Materials, Detailed section views
• Parametric modeling and library creation of HVAC & MEP components
• Extraction of Project Information
• 3D BIM to 4D BIM for scheduling and to 5D BIM for costing
• Energy Simulation
• Construction Documents